To get your wwn at your Solaris machine, you can use this command
# prtpicl -v | grep wwn

:node-wwn 50 01 04 f0 00 5f 0a 85
:port-wwn 50 01 04 f0 00 5f 0a 83
:node-wwn 50 06 0e 80 04 2a b0 04
(some output removed for brevity)

At your HP-UX machine, you can use this command
# fcmsutil /dev/td9

Vendor ID is = 0×001254
Device ID is = 0×001159
XL2 Chip Revision No is = 2.3
PCI Sub-system Vendor ID is = 0×05103c
PCI Sub-system ID is = 0×01128c
Topology = PTTOPT_FABRIC
Link Speed = 2Gb
Local N_Port_id is = 0×0a1650
N_Port Node World Wide Name = 0×50060b000023c458
N_Port Port World Wide Name = 0×50060b000023c459
Driver state = ONLINE
Hardware Path is = 0/0/14/0/0
Number of Assisted IOs = 32763725
Number of Active Login Sessions = 2
Dino Present on Card = NO
Maximum Frame Size = 2048
Driver Version = @(#) libtd.a HP Fibre Channel Tachyon TL/TS/XL2 Driver B.11.11.12 PATCH_11.11 (PHSS_31326) /ux/kern/kisu/TL/src/common/wsio/td_glue.c: Sep 5 2005, 10:14:40

At your Linux machine, used this..
# more /proc/scsi/qla2xxx/1

QLogic PCI to Fibre Channel Host Adapter for IBM FCEC:
Firmware version 3.03.18 IPX, Driver version 8.01.02-d4
ISP: ISP2312, Serial# D14082
Request Queue = 0×37680000, Response Queue = 0×37620000
Request Queue count = 4096, Response Queue count = 512
Total number of active commands = 0
Total number of interrupts = 121
Device queue depth = 0×10
Number of free request entries = 4093
Number of mailbox timeouts = 0
Number of ISP aborts = 0
Number of loop resyncs = 0
Number of retries for empty slots = 0
Number of reqs in pending_q= 0, retry_q= 0, done_q= 0, scsi_retry_q= 0
Host adapter:loop state = <READY>, flags = 0×1a03
Dpc flags = 0×4000000
MBX flags = 0×0
Link down Timeout = 030
Port down retry = 030
Login retry count = 030
Commands retried with dropped frame(s) = 0
Product ID = 4953 5020 2020 0002

SCSI Device Information:
scsi-qla0-adapter-node=200000145e24e2ch;
scsi-qla0-adapter-port=210000145e24e2ch;

Popularity: 20% [?]

You Should Also Check Out This Post:

More Active Posts: